claas.dev / embedded-fan-control
[READ-ONLY] Mirror of https://github.com/SantaClaas/embedded-fan-control.
Star
Fork 0
Watch

Commits on serial-devices

Model the three bus devices from their own documentation serial-devices
Claas committed
Rebuild the serial tool on SolidJS 2.0 and pnpm, starting with the Modbus core serial-solid-core
Claas committed
Describe the serial tool and the device documentation in the repo docs serial-repo-docs
Claas committed
Settle the imported serial tool into the monorepo serial-monorepo-integration
Claas committed
Add more experimental registers serial-import
Claas committed
Implement parity configuration as fan to support fan
Claas committed
Add timeout to cancel waiting for failed operation
Claas committed
Add additional register
Claas committed
Handle rare cases when registers are not defined
Claas committed
Generalize device UI
Claas committed
Add more formatting
Claas committed
Make dynamic device component to simplify adding registers later
Claas committed
Add fan register addresses
Claas committed
Abstract definition to simplify fan device implementation
Claas committed
Refactor operations to simplify writing device specific implementations
Claas committed
Fix writing to wrong addresses
Claas committed
Add note to help users with unintuitive behavior
Claas committed
Allow abortion to avoid dead locks
Claas committed
Enable closing a serial port
Claas committed
Remove event listeners when unmounted
Claas committed
Improve error handling
Claas committed
Remove unused code
Claas committed
Fix mistake from not saving changes
Claas committed
Setup action to automatically publish app
Claas committed
Implement basic app
Claas committed
Add clarification
Claas committed
Improve readability
Claas committed
Make sensor docs more readable and add original for reference
Claas committed
Implement reading temperature from sensor
Claas committed
Fix request not updating ports
Claas committed
Fix running subscription multiple times
Claas committed
Separate headlines
Claas committed
Add write and close
Claas committed
Add initial files
Claas committed
Document the Wi-Fi firmware in the README
Claas committed
Drop the executable bit from the Wi-Fi firmware blobs
Claas committed
Commit the CYW43439 Wi-Fi firmware instead of ignoring it
Claas committed
Bump manufacturer-docs submodule for the RadiCal fan doc
Claas committed
Bump manufacturer-docs submodule for the relay PDF
Claas committed
Bump manufacturer-docs submodule for the relay module doc
Claas committed
Document the manufacturer-docs submodule in the README
Claas committed
Add fan-documentation as a private submodule for manufacturer docs
Claas committed
Join the Wi-Fi network again after losing the link
Claas committed
Notice a broker that stopped answering
Claas committed
Publish why the controller last reset
Claas committed
Require the button to hold low instead of trusting one edge
Claas committed
Drop the energy sensor the fans do not actually report
Claas committed
Step the button through the thirds Home Assistant shows
Claas committed
Name the discovery payload builders after what they do
Claas committed
Name the modules added for sensor polling in the singular
Claas committed
Poll what the fans measure and publish it to Home Assistant
Claas committed
Record the subscribe acknowledgement instead of only logging it
Claas committed
Track the gh-stack skill and ignore the agent worktrees
Claas committed
Name the transceiver the MAX485 it is
Claas committed
Hold the RS-485 driver until the frame has actually left
Claas committed
Name modbus exception codes per function instead of sharing one enum
Claas committed
Split the modbus error so it cannot name a part its function never reads
Claas committed
Move SetPoint into its own crate so its tests run
Claas committed
Stop the fans from signalling each other back and forth forever
Claas committed
Read the fan speed on boot instead of assuming the fans are off
Claas committed