MPLAB Snap Help

Debugger to Target Communication

Note: The MPLAB X IDE software must be installed prior to connecting the MPLAB Snap In-Circuit Debugger.

The debugger is connected to the computer via a USB cable for communication and debugger power.

The debugger is connected to the target application for communication and data collection and optional debugger power.

 

	CAUTION
	Communication Failure. Do not connect the hardware before installing the software and USB drivers.

	CAUTION
	Debugger or Target Damage. Do not change hardware connections while the debugger or target is powered.

Note: Refer to the MPLAB PICkit 4 In-Circuit Debugger online help or user’s guide for information on target communication connections, debugging, requirements for debugging, programming, troubleshooting, etc.

The following figure shows a typical connection for the MPLAB Snap debugger.

Figure: MPLAB Snap Connections

Microchip Support Help Updated: 2018-08-14 12:57:18Z Help Page: 9